Installation Guide

7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□ Remove the canopy ring (O) from the canopy (C) by turning
the ring to the right until it unlocks.
□ Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
□ Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
□ Route the wires exiting the top of the fan motor (E) into
the decorative motor collar cover (D) and through the
canopy ring (O).
□ Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
2
3
1
C
A
O
SS
C
D
E
O
B
N
E
B
GG
HH
□ Remove the setscrew (HH) by turning it counterclockwise.
□ Install the downrod (B) by inserting it into the motor collar (N),
and turning it clockwise until it is tight.
□ Reinstall the setscrew (HH) turning clockwise until tight.
NOTE: This fan is equipped with a safety tab (GG). Should
the setscrew (HH) ever become loose while the fan is
running in reverse, the safety tab (GG) will engage and
stop the fan from falling.
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(HH) must be completely tightened