Installation Guide
7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□ Remove the canopy cover (HH) from the canopy (C) by turn-
ing the bottom cover counter-clockwise until it unlocks.
□ Loosen the two canopy screws (GG) located in the bottom
of the mounting bracket (A), and turn the canopy counter-
clockwise to remove the mounting bracket from the canopy
(C).
□ Route the wires exiting the top of the fan motor
assembly (E) through the decorative motor collar cover
and then the center of canopy bottom cover (HH).
□ Make sure the opening of canopy (C) is on top and
insert the ball/downrod (B) through the canopy (C).
□ Route the wires exiting the top of the fan motor
assembly (E) through the downrod as shown.
2
3
1
□ Loosen, but do not remove, the setscrew (KK) on the collar (JJ)
on top of the fan-motor assembly (E).
□ Install the downrod (B) by inserting it into the motor collar (JJ),
and turning it clockwise until it is tight.
□ Re-tighten the setscrew (KK) on the collar (JJ) on top of the fan
motor assembly (E).
NOTE: This fan is equipped with a safety tab (II). Should
the setscrew (KK) ever become loose while the fan is
running in reverse, the safety tab (II) will engage and stop
the fan from falling.
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(KK) must be completely tightened
C
A
GG
HH
C
D
E
HH
B
E
B
JJ
II
KK