Installation Guide

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Attaching the Blades

Attaching the fan blades

□ Attach one of the longer blades (F) to the fan-motor

housing (E) by inserting the blade (F) into slots in the side

of the fan motor housing (E) and aligning the three screws

holes in the blade with the holes in the center ywheel

and secure with screws (AA).

□ Repeat this step for the two remaining longer blades (F).

□ Attach one of the shorter blades (G) to the fan-motor

housing (E) by inserting the blade (G) into slots in the side

of the fan motor housing (E) and aligning the three screws

holes in the blade with the holes in the center ywheel

and secure with screws (AA).

□ Repeat this step for the two remaining shorter blades (G).

□ Make sure all the screws are rmly tightened.

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(standard mount)

□ Align the locking slots of the canopy (C) with the two

screws (CC) and alignment post (KK) in the mounting

bracket (A).

□ Push up the canopy (C) and turn clockwise until the

alignment post (KK) engages to the round hole and

the screws (CC) engage to the key slots.

□ Firmly tighten the two mounting screws (CC).

□ Install the decorative bottom cover (DD) by aligning

the cover slots with screws in the bottom of the

canopy (C). Rotate the bottom cover (DD) clockwise to

lock in place.

WARNING: When using the standard ball/downrod mounting,

the tab in the ring at the bottom of the mounting bracket

must rest in the groove of the hanger ball. Failure to properly

seat the tab in the groove could cause damage to the wiring.