Installation Guide

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

NOTE: The mounting bracket (A) is designed to slide into

place on an outlet box with the outlet box screws (NN)

installed.

WARNING: To reduce the risk of re, electric shock or

personal injury, mount to outlet box marked “Acceptable

for fan support of 35 lbs. 15.9 kg) or less”, and use screws

provided with the outlet box.

□ Loosen the two mounting screws (NN) in the outlet box.

□ Pass the 120-Volt supply wires through the center hole in

the mounting bracket (A).

□ Slide the mounting bracket (A) on to the mounting screws

(NN) and center the mounting bracket (A) in relation to the

outlet box. If necessary, use leveling washers (not included)

between the slide-on mounting bracket (A) and the outlet

box. The at side of the slide-on mounting bracket (A)

should face toward the outlet box as shown.

□ Securely tighten the two mounting screws (NN).

Hanging the fan

□ Carefully lift the fan-motor assembly (E) up to the slide-on

mounting bracket (A).

□ Seat the hanger ball portion of the ball/downrod assembly

(B) in the mounting bracket socket. Ensure that the tab on

the slide-on mounting bracket (A) socket is properly seated

in the groove in the hanger ball.