Installation Guide

12
Wiring the fan to the receiver
□ If using the 6 in. ball downrod assembly (B) provided, wire
the receiver to the fan wires by connecting the molded
adaptor plug from the receiver (M) with the molded adaptor
of the fan motor assembly (E) together.
□ If you wish to use longer downrod, you can use the
extension lead wire (42 in.) (O) provided by connecting the
molded adaptor together.
5
NOTE: The fan comes with 12 in. lead wires for use with the
provided 6 in. ball downrod assembly (B), if you wish to use
longer downrod, you can use the extension lead wire (42 in.) (O)
provided.
Assembly - Hanging the Fan (continued)
Outlet box
in the ceiling
Green
1 2 3 4
ON
DIP
O
Installing the receiver
6
□ Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
□ Insert the narrow end of the receiver (M) (as shown, at
side towards the ceiling) into the slide-on mounting bracket
until it rests on top of the ball/downrod assembly.
WARNING: To reduce the risk of re or electrical shock,
remember to disconnect power. The electrical wiring must meet
all local and national electrical code requirements. The electrical
source and fan must be 110/120 volt, 60HZ. Do not use this
product in conjunction with any variable wall control. Incorrect
wire connection can damage this receiver.
CAUTION: If other fan wires are different color, have this unit
installed by a licensed electrician.
CAUTION: Do not pull on or cut the receiver leads shorter. Do
not drop or bump the unit.
B
C
AAA
BBB
A
M