Installation Guide

Assembly - Attaching the Light Kit (continued)

Attaching the light kit tter assembly Installing the glass bowl

□ To attach the light kit tter assembly (K), remove one screw

from the light kit pan (J) and loosen but do not remove the

other two screws.

□ Connect the wires from the light kit tter assembly (K) to the

wires exiting from the bottom of the fan motor assembly (E)

by connecting the molded adaptor plugs together (black to

blue, white to white). Carefully tuck all wires into the light kit

pan (J).

□ Push light kit tter assembly (K) up to the light kit pan (J) so

that the two loosened screw heads t into the keyhole slots.

Turn the light kit tter assembly (K) clockwise to secure.

□ Re-install the screw (SS) that was removed in the rst step.

□ Make sure all the screws are rmly tightened.

□ Place the glass bowl (L) into the light kit pan (J), aligning the

three at areas on the top ange of the glass bowl (L) with the

raised dimples in the light kit pan.

□ Turn the glass bowl (L) clockwise until it stops.

2 3

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

WARNING: Allow the glass bowl to cool completely before

removing.

CAUTION: Make sure the power is off before attaching or

removing the glass bowl.