Use and Care Guide

Wiring the fan to the receiver

□ If using the 6 in. ball downrod assembly (B) provided, wire the

receiver to the fan wires by connecting the molded adaptor

plug from the receiver (I) with the molded adaptor of the fan

motor assembly (E) together.

□ If you wish to use longer downrod, you can use the extension

lead wire (66 in.) (K) provided by connecting the molded

adaptor together.

Assembly - Hanging the Fan (continued)

NOTE: The fan comes with 12 in. lead wires for use with

the provided 6 in. ball/downrod assembly (B). If you wish to

use a longer downrod, attach the 66 in. extension wire (K)

to the fan by connecting the molded adaptor plugs from the

extension wires to the adaptor plug from the fan.

Mounting the fan-motor assembly

(standard mount)

WARNING: When using the standard ball/downrod

mounting, the tab in the ring at the bottom of the

mounting bracket must rest in the groove of the

hanger ball. Failure to properly seat the tab in the

groove could cause damage to the wiring.

NOTE: The magnet is pre-attached on the canopy bottom

cover for you to remove and install easily.

□ Align the locking slots of the canopy (C) with the two canopy

screws (HH) and alignment post (QQ) in the mounting bracket (A).

□ Push up the canopy (C) and turn it clockwise until the alignment

post (QQ) engages to the round hole and the canopy screws (HH)

engage to the key slots.

□ Firmly tighten the two canopy screws (HH).

□ Align the oval shape on the canopy (C) with canopy bottom cover

(JJ). Push up the canopy bottom cover (JJ) until the canopy screw

(HH) heads engage to the slots on the canopy bottom cover (JJ) so

that the magnetic canopy bottom cover (JJ) can be attached to the

bottom of the canopy (C) properly.

Outlet box

in the ceiling

(MM)

Green