Use and Care Guide

Assembly - Attaching the Accessories

Mounting the remote control holder

□ Slide the screw cover plate up to remove it from the wall

cradle.

□ Position the wall cradle in the desired position and attach it to

the wall using the included wall cradle screws.

□ Slide the screw cover plate back onto the wall cradle to

conceal the screws.

Screw cover plate

NOTE: Screw wall anchors are included for extra support. The

included screws are designed to screw easily into the wall. If

you would like a more permanent or secure hold, install the wall

anchors prior to attaching the wall cradle to the wall.

Preparing the remote control

□ Conrm that the power to the fan is off at either the wall switch or breaker box.

□ Remove the battery cover by pressing rmly on the arrow and sliding the cover off.

□ Install two 1.5V AAA batteries (L).

□ Return power to the fan at the wall switch or breaker box.

□ If the remote control doesn’t work as normal, press then release the “Learn” button

for 1-2 seconds, located in the remote’s battery compartment, within 30 seconds of

turning on the power.

□ If pairing is successful, the blades will begin to spin.

□ Replace the battery cover on the remote control.

1 to 3 mode

□ To use more than one remote control for your fan, press the “Learn” button for 10

seconds and release within 30 seconds of turning on the power. Once pairing is

successful, the blades will begin to spin.

□ Repeat the above process for the remote controls you want to work with this fan.

□ The fan can be only controlled by 3 remote controls maximum at the same time

after “Learning”. If you use a fourth remote control to handle the fan, the rst

remote control will be replaced.

1 to 1 mode

□ To use only one remote control for your fan, press and release the “Learn” button

for 1-2 seconds within 30 seconds of turning on the power. The “1 to 3” mode will

be cleared and returned back to “1 to 1” mode.

NOTE: The remote control has already been paired to the ceiling

fan for your convenience. If you have two of the same model fans

in your home, please follow the steps below to control each fan

independently.

NOTE: The remote control battery will weaken with age and should

be replaced before leaking takes place, as this will damage the

remote control. Dispose of used battery properly and keep the

battery out of the reach of children.