Instructions / Assembly

Assembly

Attaching the top

Connecting the gas tank

After making any necessary adjustments to the parts, use

the hex bolt driver (CC) to tighten all bolts. Note: each bolt

must be tightened a few revolutions at a time. Repeat until

all bolts are tight. Do not over tighten. Over tightening may

strip bolts.

Tightening bolts

□

Open the tank door, place the tank in the holder and

connect the regulator as shown in below. Turn the handle

clock-wise to tighten. Turn the handle counter clock-wise

to remove. The hose must point down. Open the control

door and check that the valve is turned all the way

clockwise to the “OFF” position.

Tightening the threaded knobs

□

Tighten the threaded knobs found on the tank tray as below

so that the LP tank cannot move from side to side. Do not

remove plastic cap from end of threaded section.

With the help of another person, carefully place the table

top (A) onto the table base. After making any necessary

adjustments to the alignment of the table top and the

assembled base, use four 1/4"x 20 mm bolts (AA) and

Ø20xØ6.5x2.0 mm washers (BB) as shown below.

Guide the bolts through the holes in the side panels, into

the pre-drilled holes in the table top. Do not tighten

completely.

□