Use and Care Manual

Operation
11 HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
SWITCH OPERATING INSTRUCTIONS
SWITCH OPERATING INSTRUCTIONS
It is recommended you test the fan before nalizing installation.
Restore power to the circuit box. Test fan speeds with the wall
control on the left side of fan assembly.
OFF = Turns the fan off.
H = High speed.
M = Medium speed.
L = Low speed.
Test the oscillation function with the wall control on the right side
of the fan assembly.
OFF = Oscillation off.
ON = Set the fan to oscillation.
If fan doses not function properly, please refer to
“Troubleshooting” section.
WARNING: Do not manually move the fan head. Doing so
will destroy the gears in the oscillating mechanism.
JJ
LL
User Servicing Instructions
REPLACING THE FUSE
REPLACING THE FUSE
The three-prong plug is installed with a fuse (MM) that is a vital
safety device. A lament inside the fuse (MM) is designed to melt
and cut the circuit if the current gets too high. This prevents
damage to your fan and the person using it and stops the power
cord from overeating to the point where it could catch re.
If you should need to replace the fuse, grasp plug and remove from
the receptacle or other outlet device. Do not unplug by pulling on
cord. Locate the fuse cover at the end of the plug on the power
cord. Slide the fuse cover open to expose the fuse. Using
needle-nose pliers (not included), remove the fuse. Inspect the
fuse -- the small, glass tube with metal on each end -- to
determine whether it will need to be replaced. If the fuse is blown,
it will look dark and smudged or the visible wire inside will be
broken. Use a replacement the fuse with a rating of 5 amps, 125
volts only, and insert the fuse in between the metal brackets inside
the fuse housing. Slide the fuse cover shut.
WARNING: Risk of re. Do not replace attachment plug.
Contains a safety device (fuse, AFCI, LCD) that should not be
removed. Discard product if the attachment plug is damaged.