Use and Care Manual

Table Of Contents

Installing the wall mounting

bracket to the wall

7 HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Installation

WARNING: To reduce the risk of the fan falling, use all six

mounting holes in the wall mounting bracket (B) when

installing the wall mounting bracket (B).

WARNING: It is very important that you use the proper

hardware when installing the wall mounting bracket (B) as

this will support the fan assembly (A).

□ Determine the approximate position of where you

want the fan to be located on the wall. Then, locate

the stud (FF) in the wall. Position the wall mounting

bracket (B) on wood stud or wood post and mark the

location of the six holes using a pencil or a marker

(not included).

□ Use 3/32-in. drill bit (not included) to drill pilot holes

at marked locations. Then, install wall mounting

bracket (B) to the wall with wood screws (AA).

If your stud is not wide enough to support the bracket (B)

then install using the following instructions:

□ Secure a 2x6-in. wood block (F) (not included)

directly between two studs (FF). Use appropriate

fasteners and materials (not included).

□ Position the wall mounting bracket (B) on wood block

(F) and mark the location of the six holes using a

pencil or a marker (not included).

□ Use 3/32-in. drill bit (not included) to drill pilot holes

at marked locations. Then, install wall mounting

bracket (B) to the wall with wood screws (AA).

CAUTION: Carefully open the packaging and take out items

from styrofoam. Please lift the motor head with two hands by

gooseneck arm and base, and DO NOT remove the plastic

binder from the motor head until fan installation is completed.

Removing the plastic binder from the motor head before or

during installation will damage the oscillating mechanism.

CAUTION: If you are going to attach the fan assembly (A)

to a wood stud or wood post, the stud or wood post must be

at least 4 inches wide and thick enough to sustain the wall

mounting bracket (B) and the weight of the fan assembly (A).

FF F

(Not included)