Instructions / Assembly

Attaching the light kit mounting

plate to the mounting ring

Assembly — Installing the Light Kit

□ Remove one of the three light kit mounting plate

screws (JJ) from the mounting ring (TT) and loosen

the other two screws. (Do not remove.)

□ Place the key holes in the light kit mounting plate (I)

over the two screws (JJ) previously loosened from

the mounting ring (TT). Turn the light kit mounting

plate (I) until the light kit mounting plate (I) locks in

place at the narrow section of the key holes.

□ Securely tighten the two light kit mounting plate

screws (JJ) previously loosened and the one (JJ)

previously removed.

Attaching the LED light kit

and light cover

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

□ Remove one of the three light kit mounting screws

(KK) from the light kit mounting plate (I) and loosen

the other two screws (KK). (Do not remove.)

□ While holding the 18W LED light kit (J) under the fan

motor assembly (F), make the 2-pin wire

connections:

- White to white

- Black to black

□ Place the key holes in the 18W LED light kit (J) over

the two mounting screws (KK) previously loosened

from the light kit mounting plate (I). Turn the 18W

LED light kit (J) until the 18W LED light kit (J) locks in

place at the narrow section of the key holes. Secure

by tightening the two light kit mounting screws (KK)

previously loosened and the one (KK) previously

removed.

□ Raise the light cover (K) up against the 18W LED light

kit (J) and secure by tightening with the light cover

screw (LL).

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.