P roduct Maintenance Guide 11/12
Cabinetry Care, Cleaning & Adjustment Guide After installation care After your cabinets have been installed, wipe down exteriors with a clean damp cloth. Work on a small area at a time and thoroughly wipe dry. You can protect your cabinetry finish by applying a commercially available cleaning polish. An emulsion type polish such as Pledge Revitalizing Oil is formulated without silicones, petroleum solvents or wax to prevent build-up that dulls your cabinet finish and smudges to the touch.
(Shown without countertop for clarity) 1. Remove drawer from cabinet. Drawer front adjustment Drawer Adjustment Standard Runners 2. Firmly grasp runners at rear of cabinet and slide toward center of cabinet. 3. Insert drawer and fully close. Open and close repeatedly to align runners. ADJUST DRAWER FRONT BEFORE NOTE: INSTALLING DECORATIVE HARDWARE. If additional adjustment is required, loosen screws and twist drawer front for proper alignment. Tighten screws securely.
Full Extension Runners (continued) Drawer front adjustment LOCK 4. Insert drawer and fully close insuring that runners are locked into release tabs. Open and close repeatedly to align runners. 1. Rotate tab to raise or lower drawer front on either side. 2. If additional adjustment is required, loosen screws and twist drawer front for proper alignment. Tighten screws securely. ADJUST DRAWER FRONT BEFORE NOTE: INSTALLING DECORATIVE HARDWARE. Roll-out Tray Relocation/Installation 1.
Hinge Removal & Adjustment 1. Turn hinge plate mounting screws counterclockwise to loosen and adjust door up or down. Tighten screws. 2. Turn counter-clockwise to “pull” door in towards face frame. Turn screw clockwise to “push” door away from face frame. 3. Turn counter-clockwise to move door to right and turn clockwise to move door left. Easy reach corner cabinet door adjustment 1. Unscrew the hinge plate screws half a turn, on both hinge plates, to raise or lower the door. 2.
