Use and Care Manual

4. Attach runner to inside edge of face frame.
Repeat on opposite side.
5. Install roll-out tray.
2. If additional adjustment is required, loosen
screws and twist drawer front for proper
alignment. Tighten screws securely.
Drawer front adjustment
1. Rotate tab to raise or lower drawer front
on either side.
2. Slide runner into “back boot”. Repeat on
opposite side.
3. Place roll-out tray spacer behind runner. This
spacer allows roll-out tray to clear hinge
when opening. Install on hinge side only.
Double door cabinets require spacers on
both sides.
LOCK
1. Determine location desired and install
plastic “back boot” in pre-drilled holes.
Attach with screws. Repeat on opposite side.
4. Insert drawer and fully close insuring that
runners are locked into release tabs. Open
and close repeatedly to align runners.
Full Extension Runners
(continued)
Roll-out Tray
Relocation/Installation
(Shown without countertop for clarity)
NOTE:
ADJUST DRAWER FRONT BEFORE
INSTALLING DECORATIVE HARDWARE.