Use and Care Manual
1. Turn hinge plate mounting screws counter-
clockwise to loosen and adjust door up or
down. Tighten screws.
2. Turn counter-clockwise to “pull” door in
towards face frame. Turn screw clockwise
to “push” door away from face frame.
3. Turn counter-clockwise to move door to
right and turn clockwise to move door left.
1. Unscrew the hinge plate screws half a turn,
on both hinge plates, to raise or lower the
door.
2. Release the back adjustment screws to pull
the door forward or push backward.
3. Locate the front hinge adjustment screws
(insert screwdriver through the hinge arm)
turn screws clockwise to move the door
towards the edge of the cabinet. Turn
screws counter-clockwise to move the
door towards the center of the cabinet.
Easy reach corner cabinet door adjustment
Turn clockwise to
adjust contact point
out and counter-
clockwise to adjust
contact point in.
Your cabinetry may have been supplied with a soft close
door buffer. Contact point can be adjusted up to 3/16".
Adjust contact point out for larger doors and in for smaller
doors.
Soft close door adjustment
Adjust doors toward
center of cabinet per
instructions in hinge
adjustment section.
Remove hinge from
face frame, install
spacer and tighten
hinge screw. Repeat for
all hinges.
Your cabinetry may have been supplied with full overlay
mullion doors. Double door cabinets can have a gap
between the mullion doors that can be decreased by installing
supplied hinge spacers.
Mullion door spacers
Hinge Removal & Adjustment