Installation Guide
Safety Information
Grounding Instructions:
This heater is suitable for 120 volts. The cord has a plug as shown in FIGURE A.
An adapter (not included) as shown in FIGURE C can be used to connect three-blade grounding-type plugs into two-slot
receptacles. The green grounding plug extending from the adapter must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.
Ground Means
Cover of Grounded
outlet Box
Metal Screw
Grounding Pin
(A) (B)
(C)
(D)
Grounding Pin
ADAPTER
This fireplace is hot when in use. To avoid burns, never allow bare skin to touch hot surfaces.
Use handles (if provided) when moving this fireplace. Keep all flammable/combustible
materials, including (but not limited to) furniture, pillows, bedding, papers, clothes and curtains
a minimum of 3 feet from this fireplace at all times.
Proper ventilation is required when operating this fireplace. NEVER cover this device with
anything that could restrict air circulation to or from the unit.
To prevent a possible fire, DO NOT install or use this fireplace directly on carpet, beds or
similar soft surfaces as this may block air intakes, exhaust outlets or otherwise restrict air
circulation beneath the heater.
Extreme caution is necessary when this fireplace is used by or near children or individuals with
restricted mobility.
NEVER leave this fireplace unattended when in use.
Always unplug this fireplace when not in use. Turn off all controls prior to removing the plug from the power source.
This fireplace is designed for indoor use only. NEVER use this device outdoors.
Connect this fireplace only to properly grounded outlets.
Make sure plug is fully inserted into the electrical outlet to avoid fire caused by short circuit.
Use caution and do not strike the glass on this fireplace.
NEVER use this device in bathrooms, laundry areas or similar locations where it may come into contact with water.
Avoid placing the power cord in high traffic areas where it could become damaged or be a trip hazard.
DO NOT run the power cord under carpeting, furniture or appliances.
NEVER cover the power cord with throw rugs, runners or similar coverings.
DO NOT operate this device with a damaged power cord or plug.
Please read and understand this entire manual before attempting to operate or install the product.
To avoid malfunction, please be certain the input voltage of the electric
fireplace insert and the voltage of the outlet are identical before plugging in.
Check the unit for any damage that may exist (such as missing screw,
dents, etc.) before using this device.
When first used, the electric fireplace insert may emit a slight odor. This is
normal and harmless and will go away after the first few uses.
The outlet must be 15A/120V.
DO NOT touch the vent when heater is turned on.
This product is very heavy. It is recommended at least two people work together to assemble it.
You may use the carton to protect the fireplace during assembly.
Do not use power tools.
Heater
Vent
Do not
touch
3
Please contact 1-800-986-3460 for further assistance
HOMEDEPOT.COM/HOMEDECORATORS
WARNING IMPORTANT OPERATING INSTRUCTIONS.