Use and Care Manual

2
Care and Cleaning
□ Clean the fixture with a soft dry cloth.
□ Do not use any cleaners with chemicals, solvents or harsh abrasives.
Troubleshooting
Problem
Possible Cause
Solution
The fixture will not
light.
There is no power.
Check the outlet and ensure that a breaker or GFCI circuit has not been
tripped.
There is a disconnection or break in
the wire.
Follow the wires from the fixture and ensure a continuous connected
path back to the transformer.
The transformer setting is incorrect.
Check the settings on the transformer.
The light flickers
(one fixture).
There is a loose wire connector to the
fixture.
Tighten the wire connector and ensure the metal contacts pierce the
insulation on the low voltage cable from the transformer.
The lights flicker
(all fixtures).
There is a loose connection at the
transformer.
Unplug the transformer from the outlet and visually inspect the positive
and negative connecting points. Each wire should be securely screwed
in and not in contact with any other.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of ten (10) years from
date of purchase. This warranty applies only to the original consumer and only to products used in normal use and service. If this product is
found to be defective, the manufacturer's only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer's discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations,
neglect or mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance
with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse,
abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall
not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specifically disclaims any warranty, whether express or implied, of fitness for a particular purpose,
other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential
or incidental loss or damage, including but not limited to any labor / expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-800-986-3460 or visit www.homedepot.com/homedecorators
.
FCC Warning
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communication.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and receiver.
□ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.