Manualshelf

Use and Care Manual

ManualsBrandsHome Decorators Collection ManualsLandscape Lighting3-Watt Brass Outdoor Integrated LED 2700K White Warm Landscape Path Light
12
1
Item #1002 539 431
Model #ECP07-LED
Use and Care Guide
LED Low Voltage
Area Hat Lights
PACKAGE CONTENTS
A – Lamp body x1 B – Ground stake x1
C – Quick connector (with 24 in.
wire attached to lamp body) x1
D – Lamp post x1
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING: Never push the fixture into the ground by the
lamp body (A) or use a hammer to insert the ground stake (B)
into the ground.
□ Screw the lamp body (A) into the lamp post (D).
□ Insert the wire with the quick connector (C) into the groove
located on the top of the ground stake (B).
□ Prepare a hole in the installation location. Use a tool such as a
screwdriver to prepare the installation hole to ensure that the
hole is not larger than the ground stake (B).
□ Install the fixture in the ground by pushing on the foot step (1)
on the ground stake (B). Do not push on the lamp body (A).
for piercing the main low voltage cable. To avoid injury, do not
CAUTION: The wire from low voltage power unit should be 12-
16 AWG type underground low Energy Circuit Cable.
IMPORTANT: Protect the wiring by routing it in close proximity to
the light
fitting, or next to a building structure such as a house or a
deck.
The landscape wire and connector can also be hidden under
stone or buried under gr
ass at a maximum depth of 6 in. (15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, o
r fountain. Do
not submerge the fixture in water.
□ Place the wire connector (C) on opposite sides of the low voltage
cable (not included) from the transformer (not included) where the
fixture will be located. Align and fit the main low voltage cable
vertically to the slot of the wire connector (C).
□ Press the wire connector (C) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□ Once the wire connector (C) is in place, it is recommended to wrap
it with electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.
A B
C D
A
D
B
C
1
C

Summary of content (2 pages)