Use and Care Manual

ManualsBrandsHome Decorators Collection ManualsLandscape Lighting2-Watt Low Voltage Brass Outdoor Integrated LED Path Light 2700K Warm White Landscape Pack of 1

PACKAGE CONTENTS

1 Attaching and installing the light

□ Screw the lamp body (A) into the lamp-post (D).

□ Insert the wire with the quick connector (C) into the groove located

on the top of the ground stake (B).

□ Prepare a hole in the installation location. Use a tool such as a

screwdriver to prepare the installation hole to ensure that the hole

is not larger than the ground stake (B).

□ Install the fixture in the ground by pushing on the foot step (1) on

the ground stake (B). Do not push on the lamp body (A).

2 Connecting the wires

□ Place the wire connector (C) on opposite sides of the low voltage

cable (not included) from the transformer (not included) where the

fixture will be located.

□ Align and fit the main low voltage cable vertically to the slot of the

wire connector (C).

□ Press the wire connector (C) together until it is locked around the

main low voltage cable. The pre-set prongs will pierce the cable

insulation and establish contact with the electrical wire inside.

□ Once the wire connector (C) is in place, it is recommended to wrap it

with electrical tape (not included).

□ After all fixtures are installed, turn on the transformer.

A – Lamp Body x1 B – Ground Stake x1 C– Quick Connector (with 24 in. wire attached to lamp body ) x1 D – Lamp-Post x1

Foot Step

Use and Care Guide

LED LOW VOLTAGE

AREA HAT LIGHTS

Item #XXXXXXXXXX

Model #ECP18-LED

WARNING: Never push the fixture into the ground by the

lamp body (A) or use a hammer to insert the ground stake (B)

into the ground.

Assembly and Installation

WARNING: The wire connector (C) contacts have sharp edges for

piercing the main low voltage cable. To avoid injury, do not touch

the metal contacts.

IMPORTANT: Protect the wiring by routing it in close proximity

to the light fitting, or next to a building structure such as a house

or a deck. The landscape wire and connector can also be hidden

under stone or buried under grass at a maximum depth of 6 in.

(15.24cm). Do not install the fixture within 10 ft. of a pool, spa, or

fountain. Do not submerge the fixture in water.

CAUTION: The wire from low voltage power unit should be 12-16

AWG type underground low Energy Circuit Cable.

WARNING: The wire connector (C) contacts have sharp edges for

piercing the main low voltage cable. To avoid injury, do not touch

the metal contacts.

Summary of content (2 pages)

PAGE 1
Use and Care Guide Item #XXXXXXXXXX LED LOW VOLTAGE Model #ECP18-LED AREA HAT LIGHTS PAC K A G E C O N T E N T S WARNING: The wire connector (C) contacts have sharp edges for piercing the main low voltage cable. To avoid injury, do not touch the metal contacts. C A A – Lamp Body x1 D B B – Ground Stake x1 C– Quick Connector (with 24 in.
PAGE 2
Care and Cleaning □ Clean the fixture with a soft dry cloth. □ Do not use any cleaners with chemicals, solvents or harsh abrasives. Troubleshooting Problem Possible Cause Solution The fixture will not light. There is no power. Check the outlet and ensure that a breaker or GFCI circuit has not been tripped. There is a bad connection or break in the wire. The transformer setting is incorrect. One of the fixture The wire connector to the fixture is loose. lights flickers.