Use and Care Manual

ManualsBrandsHome Decorators Collection ManualsLandscape Flood Lights & SpotlightsLow-Voltage 10-Watt Brass Outdoor Integrated LED 2700K White Warm Landscape Spot Light

Item # 1002 539 385

Model #EDS22-LED

Use and Care Guide

LED Low Voltage

Bullet Lights

PACKAGE CONTENTS

A – Lamp body x1 B – Ground stake x1

C – Quick connector (with 24 in. wire

attached to lamp body) x1

Assembly and Installation

Attaching and installing the light

Connecting the wires

WARNING: Never push the fixture into the ground by the

lamp body (A) or use a hammer to insert the ground stake (B)

into the ground.

□ Insert the wire with the quick connector (C) into the groove located

on the top of the ground stake (B).

□ Prepare a hole in the installation location. Use a tool such as a

screwdriver to prepare the installation hole to ensure that the hole is

not larger than the ground stake (B).

□ Install the fixture in the ground by pushing on the foot step (1) on the

ground stake (B). Do not push on the lamp body (A).

□ The lamp body can rotate up and down 140°.

WARNING: The wire connector (C) contacts have sharp edges for

piercing the main low voltage cable. To avoid injury, do not touch

the metal contacts.

CAUTION: The wire from low voltage power unit should be 12-16

AWG type underground low Energy Circuit Cable.

IMPORTANT: Protect the wiring by routing it in close proximity to

the light

fitting, or next to a building structure such as a house or a

deck.

The landscape wire and connector can also be hidden under

stone or buried under gr

ass at a maximum depth of 6 in. (15.24 cm).

Do not install the fixture wit

hin 10 ft. of a pool, spa, or fountain. Do

not submerge the fixture in water.

□ Place the wire connector (C) on opposite sides of the low voltage cable (not

included) from the transformer (not included) where the fixture will be

located. Align and fit the main low voltage cable vertically to the slot of the

wire connector (C).

□ Press the wire connector (C) together until it is locked around the main low

voltage cable. The pre-set prongs will pierce the cable insulation and

establish contact with the electrical wire inside.

□ Once the wire connector (C) is in place, it is recommended to wrap it with

electrical tape (not included).

□ After all fixtures are installed, turn on the transformer.

A B

70°

Summary of content (2 pages)

PAGE 1
Use and Care Guide Item # 1002 539 385 Model #EDS22-LED LED Low Voltage Bullet Lights PACKAGE CONTENTS A C B A – Lamp body x1 C – Quick connector (with 24 in. wire attached to lamp body) x1 B – Ground stake x1 Assembly and Installation 1 2 Attaching and installing the light WARNING: Never push the fixture into the ground by the lamp body (A) or use a hammer to insert the ground stake (B) into the ground.
PAGE 2
Care and Cleaning □ □ Clean the fixture with a soft dry cloth. Do not use any cleaners with chemicals, solvents or harsh abrasives. Troubleshooting Problem The fixture will not light. The light flickers (one fixture). The lights flicker (all fixtures). Possible Cause There is no power. There is a disconnection or break in the wire. The transformer setting is incorrect. There is a loose wire connector to the fixture. There is a loose connection at the transformer.