Installation Guide

8. Determine the next wall cabinet to be installed and repeat the steps above but again do not fully tighten. If this
cabinet is adjacent to the rst cabinet carefully align the face frames of each cabinet and “C” clamp or “Quick-
grip” them together. Gang the cabinets together by drilling pilot holes and uses appropriate screws to secure them
together.
9. Once all your cabinets are in place tighten all the screws to lock the cabinets into place. Remove the furring strip
which is no longer needed to hold up the cabinets.
The shelf corner connector allows 2 shelves to be joined together to create a 90° corner condition.
Each corner condition requires a connector, 2 shelves, 2 installation rails to attach to the cabinets and either a 3rd
installation rail or closet panel (TCP84) which will be attached to the wall.
Multiple shelf levels will require duplicating the items above each level
except if a closet panel is used.
1. Install the closet panel or the installation rail to the wall.
2. Install installation rails on the cabinet sides at the desired shelf
height. Make sure the rail height matches the height of the rail in
step 1 or matches the pin hole locations in the closet panel.
3. Place the shelf A on the installation rails or pins if closet panel is
used.
4. Attach the corner connector to the front edge of Shelf A.
5. Place the side edge of Shelf B into the corner connector
and set otherend on the installation rail attached to
the cabinet.
72 in. Wall
cabinet
installation
continued
Shelf corner
connector
installation