Instructions / Assembly

11
Accessories such as valet rods, tie racks, belt racks and slide-out mirrors can be installed either on the interior side
wall of a cabinet or the exterior of the cabinet. Each item as it’s own installation instruction sheet that comes with the
unit. In general:
1. Installation to interior of cabinet
a. Each accessory is designed to attach using the pre-drilled holes that have been created in the side walls of
the cabinet.
b. Each accessory will have 1 or 2 rails (mirror has 2) that attach to the side wall using the screws that come with
the accessory.
c. For all units, except the mirror, you may choose the height that you wish to install the accessory at.
d. The mirror utilizes most of the side of a 42" high cabinet. It can be installed in a 42" hanging cabinet below
the hanging bar.
2. Installation on exterior of cabinet
a. The placement of an accessory on the exterior of a cabinet is completely up to the user. There are no pre-
drilled holes on the exterior.
b. Locate the accessory at the desired height.
c. Mark the attachment holes based on where the accessory rail(s) are placed.
d. Drill pilot holes into the cabinet side.
e. Attach the accessory using the screws provided in the accessory kit.
The 48" x 48" decorative panel is designed to provide a nished look for areas behind hanging clothing or areas wehre
shelving is going to be installed but not a cabinet. To install a decorative panel:
1. If needed, cut the panel to the correct size to t between two cabinets or a cabinet wall.
2. Choose between two methods of attachment:
a. Use a caulking adhesive to glue the panel to the wall.
b. Use screws to mechanically attach the panel to the wall.
SUGGESTION: Use inside corner molding to decoratively cover up the seam where the panel meetsthe wall.
See Spec Guide for details.
Accessories
installation
Decorative
back panel
installation
48"
48"
1/4"