Instructions / Assembly
HEIGHT SIDE TO SIDE DEPTH
Adjusting
doors
Attaching
decorative
hardware
To insure a perfect spacing and alignment
of your doors after installation, Technik
Closets hinges are six-way adjustable.
The decoration hardware you select may vary in size. Do not drill holes until you have determined the dimensions match the
decorative hardware you have selected. Make sure that you or your contractor adjust the alignment of all doors and drawer
fronts prior to drilling them for pulls or knobs - once the decorative hardware is installed it will be difcult to adjust the doors and
drawer fronts.
1. Clamp a piece of wood to the front side of the door or drawer front, at handle location.
2. From the inside of the door use a
3
/
16" drill bit and be sure to drill completely through the door or drawer front into
the block this allow for a clear hole. Push the bolt through the hole and apply the hardware. Tighten from the inside
of the door or the drawer with a screwdriver.
We hope your Home Decorators Collection Closet project has been a pleasant and rewarding experience.
Loosen center screw on each hinge.
Move door to desired position. Re-tighten
each screw.
Using a Phillips screw driver, rotate
front screw moving the door to desired
position.
Using a Phillips screw driver, rotate
back screw moving the door to desired
position.
STEP 1
Partially open drawer
STEP 3
For slide on right side of drawer box
locate the black tab and push DOWN
to release. With both tabs released at
same time slide out the drawer.
STEP 4
To re-install drawer, simply align the
drawer slides on both sides and gently
push drawer closed and re-open.
Locking tabs do not need to be pressed.
STEP 2
For slide on the left side of drawer box
locate the black tab and push UP to
release.
STEP 5
Open and close drawer several times to
align the slides.
DRAWER FRONT ADJUSTMENT
If additional adjustment is required,
loosen screws and twist drawer front
for proper alignment. Tighten screws
securely.
NOTE: ADJUST DRAWER
FRONT
BEFORE INSTALLING
DECORATIVE HARDWARE!
Removing/
adjusting
drawers and
drawer fronts