Instructions / Assembly

42 in. Wall

cabinet

installation

1. Place the upper cabinet on the lower cabinet and mark the sides and top of the upper wall cabinet on the drywall,

remove the wall cabinet.

2. On the wall locate the studs and mark the center of each stud approximately 3" from the top and bottom of the

wall cabinet.

3. Transfer these measurements to the two horizontal installation rails, along the back of the wall cabinet at top

and bottom.

4. Drill (4) mounting holes thru the installation rails top and bottom of wall cabinet with a 3/32" drill bit.

STEP 5 STEP 6 STEP 7

STEP 2 STEP 4

NOTE: If you can only nd one stud,

use a drywall toggle bolt to create a

second attachment point. (Consult

your local hardware store for the

correct toggle for your wall construc-

tion).

**WALL CABINET MUST HAVE

FOUR ATTACHMENT POINTS!

5. Now place the wall cabinet on top of the base cabinet and align and make sure it’s level – hold in place with “Quick

Grips” or G-clamps.

6. Attach base cabinet to wall cabinet using #8 x 1¼" pan head screws.

7. Attach the wall cabinet thru the drywall and into the wood studs using

10 x 3" pan head screws or install drywall

toggle bolt if necessary - DO NOT FULLY TIGHTEN! Check the level and adjust as needed. Once you are happy with

the alignment and level of the two cabinets, fully tighten all the attachment screws.