Use and Care Manual
1
Item #1002 539 451
Model #ETD61-LED
Use and Care Guide
LED Low Voltage
Surface Mount Step Lights
PACKAGE CONTENTS
A – Lamp body x1 B – Quick connector x1 C – Self-threading screw x2 D – Plastic Anchor x2
Assembly and Installation
This document provides three different methods for installing the light. Please choose one of the three mounting options below:
Option 1 – Installing the light on a
wooden wall
Option 2 – Installing the light on a wooden
wall with the wire pointed down
□ Using the included template, mark the correct locations for mounting.
□ Use a 1/2 in. diameter bit on the drill to bore a wiring hole.
□ Pass the quick connector (B) through the hole from the other end to
connect the female terminal of the lamp (A).
□ Route the wire slowly into the wire hole until the base is flush with
the wall.
□ Position the lamp (A) against the wall and secure with self-threading
screws (C).
□ Proceed to Connecting the Wires on page 2.
□ Using the included template, mark the correct locations for mounting.
□ Place the lamp body (A) as indicated by the horizontal mark on the
base and secure with self-threading screws (C).
□ Connect the quick connector (B) with the female terminal of the
lamp (A).
□ Proceed to Connecting the Wires on page 2.
A B C D
A
C
B
A
C
B