Manualshelf

Use and Care Manual

ManualsBrandsHome Decorators Collection ManualsLandscape Flood Lights & Spotlights10-Watt Brass Outdoor Integrated LED 2700K Ultra Warm Landscape Flood Light
12
1
Item #1002 539 387
Model #ETS22-LED
Use and Care Guide
LED Low Voltage
Flood Lights
PACKAGE CONTENTS
A – Lamp body x1
B – Ground stake x1
C – Quick connector (with 24 in. wire attached to lamp body) x1
Assembly and Installation
Attaching and installing the light
Connecting the wires
WARNING: Never push the fixture into the ground by the
lamp body (A) or use a hammer to insert the ground stake (B)
into the ground.
□ Insert the wire with the quick connector (C) into the groove located
on the top of the ground stake (B).
□ Prepare a hole in the installation location. Use a tool such as a
screwdriver to prepare the installation hole to ensure that the hole is
not larger than the ground stake (B).
□ Install the fixture in the ground by pushing on the foot step (1) on the
ground stake (B). Do not push on the lamp body (A).
□ The lamp body can rotate up and down 140°.
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION: The wire from low voltage power unit should be
12-16 AWG type underground low Energy Circuit Cable.
IMPORTANT: Protect the wiring by routing it in close proximity to
the light
fitting, or next to a building structure such as a house or a
deck.
The landscape wire and connector can also be hidden under
stone or buried under gr
ass at a maximum depth of 6 in. (15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, o
r fountain. Do not
submerge the fixture in water.
□ Place the wire connector (C) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the fixture will be
located. Align and fit the main low voltage cable vertically to the slot of the
wire connector (C).
□ Press the wire connector (C) together until it is locked around the main low
voltage cable. The pre-set prongs will pierce the cable insulation and
establish contact with the electrical wire inside.
□ Once the wire connector (C) is in place, it is recommended to wrap it with
electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.
A
B
C
40°
100°
A
B
C
1
C

Summary of content (2 pages)