Use and Care Manual

Item #1002 539 456

Model #EXQ03-LED

Use and Care Guide

LED Low Voltage

Wall Lights

PACKAGE CONTENTS

A – Lamp base x1 B – Lamp cap x1 C – Quick connector x1 D – Self-Threading screw x2 E – Plastic Anchor x2

Assembly and Installation

This document provides three different methods for installing the light. Please choose one of the three mounting options below:

Option 1 – Installing the light on a

wooden wall

Option 2 – Installing the light on a wooden wall

with the wire pointed down

□ Separate the lamp base (A) from the lamp cap (B) by removing the

screws as shown. Using the included template, mark the correct

locations for mounting.

□ Use a 1/2 in. diameter drill bit to drill a hole for the connector wire.

□ Pass the quick connector (C) through the 1/2 in. hole from the

backside to connect the female terminal of the base (A).

□ Route the wire slowly into the 1/2 in. wire hole until the base (A) is

flush with the mounting surface.

□ Position the base (A) as indicated by the horizontal mark on the base

(A) and secure with the self-threading screws (D).

□ Reattach the lamp cap (B) to the base (A) using the previously-

removed screws.

□ Proceed to Connecting the Wires on page 2.

□ Separate the lamp base (A) from the lamp cap (B) by removing the screws

as shown. Using the included template, mark the correct locations for

mounting.

□ Align the wire from the base (A) with the notch on the bottom of the

base (A). Position the base (A) as indicated by the horizontal mark on the

base (A) and secure with the self-threading screws (D).

□ Reattach the lamp cap (B) to the base (A) using the previously-removed

screws.

□ Connect the female wire end from the base (A) to the male wire end of the

quick connector (C).

□ Proceed to Connecting the Wires on page 2.

B C

D E

PAGE 1
Use and Care Guide Item #1002 539 456 Model #EXQ03-LED LED Low Voltage Wall Lights PACKAGE CONTENTS A A – Lamp base x1 B B – Lamp cap x1 C C – Quick connector x1 D D – Self-Threading screw x2 E E – Plastic Anchor x2 Assembly and Installation This document provides three different methods for installing the light.
PAGE 2
Assembly and Installation (continued) Option 3 – Installing the light on a wall using Connecting the wires plastic anchors □ □ □ □ □ □ □ Separate the lamp base (A) from the lamp cap (B) by removing the screws as shown. Using the included template, mark the correct locations for mounting. Use a 1/4 in. drill bit to drill holes for the plastic anchors (E). Insert the plastic anchors (E) into the holes and tap flush with the mounting surface.
PAGE 3
Care and Cleaning □ □ Clean the fixture with a soft dry cloth. Do not use any cleaners with chemicals, solvents or harsh abrasives. Troubleshooting Problem The fixture will not light. The light flickers (one fixture). The lights flicker (all fixtures). Possible Cause There is no power. There is a disconnection or break in the wire. The transformer setting is incorrect. There is a loose wire connector to the fixture. There is a loose connection at the transformer.