Use and Care Manual

14
Assembly (continued)
6
CHECKING THE TABLE AND PLACE THE GLASS BEADS
Once all of the bolts are in place, fully tighten all the bolts using the hex wrench (GG).
Place the glass beads (I) into the square burner bowl (J).
WARNING: Surfaces on the fire table can remain extremely hot for a period after
use. Allow 45 minutes to cool down before touching or moving the fire table.
B
I
T
PILOT
HOUSING
INCORRECT
CORRECT
PILOT
BURNER
TUBE
DO NOT BLOCK
OPENING
CAUTION: To ensure proper function, the screen on the pilot housing should be free of glass beads.