Use and Care Manual

Please note that changes or modications of this product is not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation..
LIGHTING PARTNERS JAX, INC. 3723 Regent Boulevard, Jacksonville, FL 32224. Phone: [phone].
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
7
FCC Warning
Care and Cleaning
Troubleshooting
□
Clean the light xture with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Problem Possible Cause Solution
The bulb will not light. □ The bulb is burned out. □ Replace the light bulb.
□ The power is off.
□ Ensure that the power supply is turned on.
□ Check the wiring.
□ The circuit breaker is off. □ Ensure that the circuit breaker is set in the
on position.
The fuse blows or a circuit breaker
trips when the light is turned on.
□ There is an exposed wire.
□ There are too many items on one circuit.
□ Discontinue use of the light xture.
Unplug other items on the circuit.
r
□ Contact a qualied electrician or
call the Customer Service Team at
1-800-986-3460.
□