Instructions / Assembly

The Magellan Group, LTD. • 4317 Santa Ana Street, Suite A • Ontario, California 91761
[phone] • www.woodlandhomedecor.com
CORNER SHELF INSTALLATION
(1) Hold the shelf against the wall in desired
location. Using a level and a pencil, lightly
mark both walls along the bottom of the
shelf.
(2) Hold a rail against the wall, with the top of
the rail touching the pencil line. Mark the
screw holes by pressing a thin, sharp drill bit
(or a thin phillips screwdriver) through each
of the holes with enough pressure to make a
mark on the wall. Repeat for the other rail,
assuring that the two rails are equal distance from the corner.
(3) Using a 3/32" drill bit, drill holes in the four marked locations. For holes that hit on a wall stud, do
not re-drill the hole. For holes that did not hit on a wall stud, re-drill the holes using a 3/16" drill
bit. Insert plastic anchors into the holes, tapping them in gently with a rubber mallet until flush
with the wall.
(4) Mount the rails to the wall using the four large screws provided. Tap the wood buttons into the
holes to conceal the screws.
(5) To attach the shelf to the rails, install the small screws provided, down through the small holes on
each side of the top of the shelf. Install screws just until flush with the shelf surface, no deeper.
Small Wood Screws