Pre-Assembly HARDWARE INCLUDED AA BB DD EE Part Description CC Part Number Quantity 180000010600 300000190100 5 1 8 8 AA Anchor Screw BB Wall Anchor CC Screw 4mm x 8mm DD Screw 6mm x 16mm 180000010100 180000030200 EE Washer 180000050600 5 NOTE: Hardware not shown to actual size. PRODUCT SPECIFICATIONS Voltage 120 VAC, 60 Hz Amps 12.5 Amps Watts 1500 Watts PLANNING ASSEMBLY Before beginning assembly of product, make sure all parts are present.
Pre-Assembly (continued) PACKAGE CONTENTS A B D C Part Description E F G H I Quantity A Mounting Bracket-bottom 1 B Mounting Bracket-top 1 C Fireplace 1 D Front Frame 1 E Base Bracket 1 F Base 1 G Remote Control 1 H AAA Battery 2 I Acrylics Pieces Varies J Screw Set Varies 6 J HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Installation Operation Options T 1. Hanging on a wall with provided mounting bracket. 2. Freestanding using the pedestal base. Follow installation instructions below based on installation preference. Option 1 Option 2 Wall Hanging....page 9 Pedestal Base....page 13 7 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Installation Operation - Wall Hanging Hanging on a wall Y However, when choosing a location be sure to follow the somewhere general instructions included. For best results install out of direct sunlight. Power supply service must be either completed or placed within Min. 60 cm 24 in. Min. 5 cm 2 in. Min. 5 cm 2 in. Min. 5 cm 2 in. WARNING: Keep drapery and other furnishings at least 3 ft / 1 m Clearance to combustibles Sides 2 in. / 5 cm Floor 2 in. / 5 cm Top 24 in. / 60 cm Bottom 2 in.
Installation - Wall Mounting Operation 1 2 Choosing a Wall Location Choose a wall location to attach the Mounting Bracket (B). Position the Mounting Bracket (B) in the desired location. Use a level to align the bracket and mark the four holes with a pencil. Use the two marked center holes of the Top Mounting Bracket (B) to measure and locate the hole for the Bottom Bracket (A). Follow the dimensions in the drawing. Mark the Bottom Bracket (A) hole with a pencil. Drilling the Holes Drill five 7/25 in.
Installation - Wall Mounting (continued) Operation Operation 5 Hanging the Fireplace Hang the Fireplace (C&D) on the hook at the top of the Top Mounting Bracket (B) and let the Fireplace (C&D) seat onto the Bottom Mounting Bracket (A). B C&D A 10 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Installation - Wall Mounting (continued) Operation Operation 6 Securing the Fireplace Secure the fireplace (C&D) to the Bottom Mounting Bracket (A) with the retaining Screw (CC ). Continue to the fuel bed setup instructions (Page 15). A A CC 11 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Installation - Pedestal Base Operation 1 Fastening the Base Bracket Use two Screws (DD) and Washers (EE) to fasten the Bracket (E) to the bottom of Fireplace (C). C EE E 2 DD Fastening the Base Bracket to the Back Use two Screws (DD) and Washers (EE) to fasten the Bracket (E) to the back of the Fireplace (C). C E EE DD 12 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Installation - Pedestal Base (continued) Operation 3 Attaching the Base Attach the Base (F) using four Screws (DD) and Washers (EE) to the Base Bracket (E). E F DD EE 13 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Fuel Bed Setup Instructions Operation 1 Removing the Frame Remove the four screws that attach the Frame (D) to the Fireplace (C) and remove the Frame (D). C D 2 Placing the acrylic pieces Place the Acrylic Pieces (H) on the Fuel bed. Place the Frame (D) back on the Fireplace (C) with the four screws removed in Step 1. C D H 14 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Operation Operation Display Control Panel T 4. Thermostat up button 1. Power Button 4. Thermostat Down button 3. Heater Button 2. Flame effect button 4. Thermostat Down button 3. Heater Button 4. Thermostat up button 7. Color themes button 5. Brightness button 7. Color themes button 6. Timer button Control Panel Remote Control 15 HOMEDEPOT.COM/HOMEDECORATORS Please contact 1-800-986-3460 for further assistance.
Operation Operation (continued) 2 1 Powering the Fireplace Push the Power button to supply power to all Turns the Flame Effect On and Off, actived by pressing the button on the remote. Cycles the unit through the four settings: standby mode. Push the Power button again to turn off all functions. ‘FE’, Flame and Fuel bed ON. ‘F-’, Flame ON, Fuel bed OFF. ‘-E’, Flame OFF, Fuel bed ON. ‘--’, Flame and Fuel bed OFF. NOTE: All previous settings are held in memory, so the with the same settings.
Operation Operation (continued) 7 Adjusting the Color Themes Press the Themes button on the control panel or remote control to change the Color Themes. There are 8 settings: OFF, Red, Sky Blue,Orange, Blue, Purple, Green and Cycling as indicated on the Display: 1-OFF 2-Red 3-Sky Blue 4-Orange 5-Blue 6-Purple 7-Green 8-Cycle from 2 to 7. NOTE: 8 Using the Power Cord Correctly This heater is for use on 120 volts. The cord has a plug as shown in the figure. Connect to properly grounded outlets only.
