Use and Care Manual

ManualsBrandsHome Decorators Collection ManualsKitchen96 in. x 4.5 in. x 0.2 in. Toe Kick in Veiled Gray

AFTER INSTALLATION CARE

After your cabinets have been installed, wipe down exteriors with a clean damp cloth. Work on a small area at a time and

thoroughly wipe dry.

DO NOT USE agents containing acetone, acetate or ethyl alcohol. Avoid using harsh solvents and/or abrasives, such as

turpentine, as they may break down bonds on edge banding. If you use ammonia-based cleaners, be sure to dilute the

mixture before use.

EVERYDAY CARE

It is important to wipe up spills and water marks as they occur. Be sure to pay special attention to areas around the sink

and dishwasher. Avoid draping damp or wet dish towels over the door of the sink base cabinet. Over time, this moisture can

cause permanent water damage to the door.

Avoid spray-type polishes containing petroleum solvents, as they are flammable and toxic if swallowed. Use a damp

cloth when cleaning normal household spills, and after wiping thoroughly, dry the surface with a lint-free cotton cloth. For

stubborn stains, it may be necessary to use a mild detergent with warm water. Be sure to always dry the surfaces that were

wiped down immediately.

Never use abrasive cleaners, scouring pads or powdered cleansers. Do not allow oven cleaner to come into contact with

any part of your cabinets. Do not use a dish cloth to wipe your cabinet exterior, since it may contain remnants of grease or

detergents.

We recommend against using waxes or products containing wax because it may lead to discoloration. If a damp cloth does

not sufficiently clean an area, we recommend a non-detergent, non-abrasive household cleaner.

Cabinet Care, Cleaning & Adjustment Guide

Summary of content (5 pages)

PAGE 1
Cabinet Care, Cleaning & Adjustment Guide AFTER INSTALLATION CARE After your cabinets have been installed, wipe down exteriors with a clean damp cloth. Work on a small area at a time and thoroughly wipe dry. DO NOT USE agents containing acetone, acetate or ethyl alcohol. Avoid using harsh solvents and/or abrasives, such as turpentine, as they may break down bonds on edge banding. If you use ammonia-based cleaners, be sure to dilute the mixture before use.
PAGE 2
WEAR & TEAR Daily use can result in surface damages to your cabinetry. A touch-up pen and fill stick kit can assist you with minor repairs. Small scratches can be covered by “coloring” with the color matched pen. Deep scratches or gouges can be filled with the color matched fill stick. To use the fill stick, run it firmly along the scratch, applying enough pressure to fill the scratch. The touch-up kit is avaliable for purchase.
PAGE 3
SHELF PINS DRAWER FRONT ADJUSTMENT Cabinet shelves feature locking shelf pins. To release, simply push in the tab and lift the shelf drawer is locked on runners, rotate additional adjustment is required, loosen 1 While 2 Ifscrews tab to raise or lower drawer front on either and twist drawer front for proper side. alignment. Tighten screws securely. DRAWER REMOVAL/ADJUSTMENT open drawer to get access to 1 Partially underneath.
PAGE 4
ROLL-OUT TRAY RELOCATION/INSTALLATION location desired and install 1 Determine plastic “back boot” in pre-drilled holes. Attach with screws. Repeat on opposite side. runner into “back boot”. Repeat on 2 Slide opposite side. In a standard Base Cabinet there are two locations a Roll-out Tray can be installed, indicated by the two sets of pre-drilled holes on the back panel. runner to inside edge of face frame. 3 Attach 4 Install roll-out tray.
PAGE 5
EASY REACH CORNER CABINET DOOR ADJUSTMENT DEPTH SIDE TO SIDE Rotate the back screw (circled) for front to back door adjustment. Rotate front screw (circled) for horizontal door adjustment. EASY REACH DOOR TO DOOR ADJUSTMENT DEPTH SIDE TO SIDE Rotate the back screw (circled) for front to back door adjustment. Rotate front screw (circled) for horizontal door adjustment. SOFT CLOSE DOOR ADJUSTMENT The Soft Close feature is ON when the switch is towards the "-" symbol.