Instructions / Assembly

13
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance
1
Removing the access panels
□ Turn the firebox master power “on/off” switch to the “off”
position, (located behind the front access panel).
□ Pull the mantel away from the wall, as you need to access
the back of the firebox. Unplug the firebox from the power
outlet.
□ Let the firebox insert cool if it has been operating.
□ Looking at the back of the firebox, locate the two small
access panels.
□ Remove the screws in each panel using a Phillips or
flathead screwdriver. Pull the access panel toward you. The
light bulbs are attached to a slide, which will bring them to
the edge of the firebox for your convenience.
2
Replacing the bulbs
□ Carefully remove the burnt light bulb. This may require
holding the light socket with one hand while unscrewing
the light bulb with the other hand.
□ Install the new light bulbs.
□ Push in the slides and replace the access panels.
□ Insert and tighten the screws in each panel that were
removed.
□ Plug the firebox into the power outlet and return your
mantel to its original position against the wall.
□ Turn the firebox master power “on/off” switch to the “on”
position and press the power button (1) on the control
panel (P). Check that the replacement bulbs are working.
WARNING: Do not exceed 40 Watts per bulb. Use of
higher rated light bulbs may cause overheating and result
in a fire, causing property damage, personal injury, or loss
of life.
NOTE: This fireplace insert uses two clear 120 Volt, 40 Watt,
E-12 socket base light bulbs (small base, chandelier candle
type bulbs). The light bulbs are located at the bottom of the
unit. You can change the light bulbs from the back of the
firebox. For convenience, if one of the light bulbs burns out, it
may be easier to replace all of the light bulbs at the
same time.
ACCESS PANELS
Maintenance
1 3 2 2 4 5
P