Instructions / Assembly

Please contact 1-877-592-5233 for further assistance.

HOMEDEPOT.COM/HUBSPACE

LEARN

SETTING UP THE TRANSMITTER

Operation

NOTE: Batteries will weaken with age and should be replaced

before leaking takes place as this will damage the remote

control. Dispose of used batteries properly and keep them out

of the reach of children.

LEARNING PROCESS

Remove the battery cover by pressing ﬁrmly on the arrow and

sliding the cover off.

Install two 1.5V AAA batteries (CC) (included).

Replace the battery cover on the remote control (K).

NOTE: If installing multiple fans on separate remotes, only

the fan being programmed should have AC power turned ON.

All other fans, even if they have already been programmed,

should have AC power OFF so they do not memorize other

remotes during the learning process. Separate the fan power

switches by approximately 2 meters.

Within 30 seconds of turning AC power on, press and release

the "LEARN" button located in the remote's battery compartment

to enter the learning function. The down light of your fan, if

applicable, will blink, and the fan blades will start to spin.

The fan will now accept commands from the added remote.

Ensure AC power to the fan is OFF to begin the learning process.

Slide the dip switch in the battery compartment to the "1" position.

Turn the fan’s AC power ON.

To add a remote to your fan’s memory, use the steps below:

LEARN

NOTE: The remote has been pre-paired in the factory for your

convenience.

IMPORTANT: If you have two or more fans, please follow

steps below to control each fan independently. Also follow

steps below to re-pair the remote and the receiver when needed.

NOTE: The dip switch in the battery compartment has been

set on “0” position for your convenience. If you want to

re-pair the remote, please set the dip switch on “1” position.

If you would like to set the dip switch back to the "0" position

after a learning, please re-pair the remote by following the

learning process again.