Instructions / Assembly

How to Install in Wood Stud:

HOOK RAILS

Tape Measure

Phillips Head

Screwdriver

Drill and 3/32 Drill Bit Level

WHAT YOU WILL NEED:

Place hook rail in desired location

and mark mounting hole locations.

Lay Hook Rail over pilot holes and use

provided screws to attach it to the wall.

Full Details and Drywall Installation Below.

WARNING

AVERTISSEMENT

ADVERTENCIA

Wear Safety Goggles

Portez des Lunettes de Sécurité.

Utilice Gafas Protectoras

Drill 3/32” pilot holes on markings.

PORTE-SERVIETTE DE 68 CM (24 PO)

TOALLERO DE 24" (68 CM)

Screws (Included)

If Screw caps are included place over screw hole.

Pencil

INSTALLATION INSTRUCTIONS:

When drilling into the wall, exercise care to avoid any electrical wiring or plumbing that may

be located behind the wall. Damaged electrical wiring can cause electrical shock and/or fire.

INSTRUCTIONS FOR SOLID WOOD OR WOOD STUD MOUNT INSTALLATION:

1. Place hook rail in desired location.

2. Mark mounting hole locations.

3. Drill 3/32 in (0.23 cm) pilot holes.

4. Fasten hook rail using screws provided.

The maximum capacity for this hook rail is 35 lbs (15.8 kg) when mounted into solid wood or

wood studs.

INSTRUCTIONS FOR NON-STUD MOUNT:

1. Place hook rail in desired location.

2. Mark mounting hole locations.

3. Place screwdriver into recess of anchor. Press into drywall at marked location while turning

anchor clockwise until it is seated flush with the wall.

4. Place hook rail in position over installed anchor. Insert screw and tighten into place with

screwdriver.

NOTE: Anchors are intended for use in drywall when not mounting into wood stud or wood.

Anchors should not be used for any other application.