Installation Guide

ManualsBrandsHome Decorators Collection ManualsBath17.75 in. W Solid Surface Sidesplash in Polar Gray

INSTALLATION INSTRUCTIONS FOR

VANITY TOP, BACKSPLASH & SIDESPLASH

VANITY TOP CARE & MAINTENANCE

Your vanity top will remain in its original state if you maintain and clean it properly. Clean the surface with a glass cleaner or other household

cleansers that do not contain chlorine. Avoid using abrasive cleaners as they will damage the surface.

SIDESPLASH/BACKSPLASH INSTALLATION

1. Apply a thin bead of silicone on the back of the sidesplash/backsplash. Carefully

place and secure it to the wall. Remove any excess compound with a wet rag.

2. Once secured, seal bottom portion of the sidesplash/backsplash by applying a thin

bead of silicone on it. Let rest until dry.

SILICONE

backsplash sidesplash

LIMITED LIFETIME WARRANTY APPLICABLE TO USA

The product has been manufactured by WoodCrafters Home Products, LLC and is warranted under normal use and service, to be free from defects in material and

workmanship for the life of the product from the date purchased. During this warranty period, WoodCrafters Home Products, LLC will repair or replace at

WoodCrafters Home Products, LLC sole option, free of charge, any defective part or parts returned with shipping charges prepaid to the distribution center listed

below. Please include the original receipt with date of purchase and the nature of the problem. Merchandise not returned prepaid will be refused. Our warranty does

not cover damage or failure caused by abuse, misuse, abnormal usage, faulty installation, improper maintenance or any repair other than those by WoodCrafters

Home Products, LLC. There are no obligations or liabilities on the part of WoodCrafters Home Products, LLC for consequential damage arising out of or in connection

with the use or performance of the product or any indirect damages included, but not limited to labor charges for installation or removal. This warranty gives you

speciﬁc legal rights, and you may also have other rights that may vary from state to state. Further information regarding this warranty may be obtained without charge

by contacting WoodCrafters Home Products, LLC Customer Service. If any parts are missing or damaged, please call WoodCrafters Home Products, LLC Customer

Service at (800) 235-7747, between 8 a.m. and 5 p.m. C.S.T.

WoodCrafters Home Products, LLC

3700 Camino de Verdad, Weslaco, TX 78596-1266

VANITY TOP INSTALLATION

1. Set the vanity top on top of the vanity base, checking the location of the p-trap

and drain.

2. Remove the top and install the faucet per manufacturer’s installation

instructions.

3. Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten

the pop-up drain. Over tightening may cause cracks on the marble top.

4. Apply a thin bead of silicone compound around the vanity base and set the

vanity top carefully in place. Remove any excess silicone compound with a

wet rag.

5. Attach water lines to faucet and connect the p-trap and drain.

SILICONE

Customer Service USA

1(800) 235-7747

Centro de Atención al Cliente México

01 (800) 570-0319

32906

Rev. October 2014

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR VANIT Y TOP, BACKSPL ASH & SIDESPL ASH Customer Service USA 1(800) 235-7747 Centro de Atención al Cliente México 01(800) 570 -0319 VANITY TOP INSTALLATION 1. Set the vanity top on top of the vanity base, checking the location of the p-trap E N O and drain. C LI I S 2. Remove the top and install the faucet per manufacturer’s installation instructions. 3. Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten the pop-up drain.
PAGE 2
INSTRUCCIONES DE INSTALACIÓN PARA LAVABO, ZOCLO TRASERO Y ZOCLO LATERAL Customer Service USA 1(800) 235-7747 Centro de Atención al Cliente México 01(800) 570-0319 INSTRUCCIONES DE INSTALACION DEL LAVABO 1. Coloque el lavabo sobre la base del gabinete verificando la ubicación correcta de la trampa y el drenaje. N O IC IL S 2. Remueva el lavabo e instale las llaves de acuerdo con las instrucciones de instalación del fabricante. 3. Ajuste manualmente el tubo del drenaje con una llave apropiada.