Instructions / Assembly

Attaching the light kit mounting

plate to the mounting ring

□ Remove one of the three light kit mounting plate

screws (OO) from the mounting ring (PP) and loosen

the other two screws. (Do not remove.)

□ Place the key holes in the light kit mounting plate (I)

over the two screws (OO) previously loosened from

the mounting ring (PP). Turn the light kit mounting

plate (I) until the light kit mounting plate (I) locks in

place at the narrow section of the key holes.

□ Securely tighten the two light kit mounting plate

screws (OO) previously loosened and the one (OO)

previously removed.

Attaching the LED light kit

and glass shade

Assembly — Installing the Light Kit

□ Remove one of the three light kit mounting screws (QQ)

from the light kit mounting plate (I) and loosen the other

two screws (QQ). (Do not remove.)

□ While holding the 20W LED light kit (J) under your fan

motor assembly (F), make the 2-pin wire connections (TT):

- White to white - Black to blue

□ Place the key holes in the 20W LED light kit (J) over the

two mounting screws (QQ) previously loosened from the

light kit mounting plate (I). Turn the 20W LED light kit (J)

until the 20W LED light kit (J) locks in place at the

narrow section of the key holes. Secure by tightening

the two light kit mounting screws (QQ) previously

loosened and the one (QQ) previously removed.

□ Position the notches (RR) in the outer rim of the plastic

shade (K) so they line up with the tabs (SS) on the inside

of the rim on the 20W LED light kit (J). Carefully lift the

plastic shade (K) up inside the 20W LED light kit (J) and

secure it to the fan by turning the plastic shade (K)

clockwise until snug. DO NOT OVERTIGHTEN.

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.