Installation Guide

24
Installation Practices
Termination Fitting Assembly (Parts 11-464-XXX)
Step 1 Cut HOME-FLEX® tubing to length
Route CSST through structure to the desired
location of the termination ange. Bend
tubing as required so it exits the structure in
desired direction of the termination plate.
Cut the excess CSST so about 2" of tubing
extends beyond the wall.
Step 2 Remove tubing jacket to prepare for tting
assembly
Using a utility knife, strip the yellow tubing
jacket back 2 valleys from the end of the
tubing. Also remove the yellow warning
label from the tting assembly.
DO NOT use a tube cutter.
Step 3 Place ange nut over HOME-FLEX® tubing
Slide the termination ange over the tubing
with the threaded end pointing toward the
end of the tubing.
DO NOT SECURE THE FLANGE.
Step 4 Place retainer ring on HOME-FLEX® tubing
Place the retainer ring in the rst valley of the
tubing. Being careful to not dent the tubing,
clamp the retainer ring in place by applying
gentle pressure 360° around the ring. It
should t tightly and not easily spin around
the tubing.