Installation Guide
Doc. ID: 127
Rev: 6
Effective: 3/29/2018
Page | 7
Floating Installation
Step 1 – Install the First Row
•
When possible, begin installation from the straightest wall. If possible, install the flooring perpendicular to the joists.
•
Cut off the tongue from the first row planks.
•
Allow 1/2” expansion gap between plank and the walls. Use spacers or board.
•
Place the first plank with the groove side facing away from the walls.
•
Place the upper drop-lock end of the second plank on the lower drop-lock end of the first plank. The ends do not click lock. Maintain
straight edge along the rows.
•
Continue placing the succeeding planks to complete the row
Step 2 – Install the Second and Remaining Rows
•
Cut off a section the first plank lengthwise to ensure 6” joints staggering.
•
Hold the plank with the tongue facing the previous row. Keep it at about 30° angle.
•
Insert the tongue into the groove.
•
Make sure the tongue are snuggly and securely engaged in the groove by exerting a constant pressure in the direction of the groove.
•
Maintain the pressure while pressing the plank flat to lock the edge joints.
•
If there is a slight gap along the edge joints, it can be eliminated with the help of a tapping block and a plastic mallet. Use caution to
prevent impact damage.
Step 3 - Install the Last Row
•
Use the pull bar to draw the last row to fit tightly to the previous row.