Installation Guide

Home Master
®
Mini Assembly & Installation Manual
Assembly Instructions
1. Unbox and unwrap the system. Keep plastic bags out of reach of
children.
2. Locate filter and base. Notice that the filter is already fit onto base.
Please gently double-check that its snug tight.
3. Notice the red collet rings on the inlet and outlet ports on the
base. Look for the IN and OUT labels found on the underside of the
base.
Friendly Support: 1-877-693-7873
[e-mail]
Home Master
®
Mini Assembly & Installation Manual
4. Locate pre-assembled 36” tubing with
the kitchen faucet diverter valve on one
end and the elbow fittings on the other.
Notice that one of the elbow fittings has
its connecting tube tagged with black
tape. IMPORTANT: Gently push this
elbow stem into the red collet ring port
labeled IN.
About 1/8” of the stem will still be visible
when the stem is inserted fully as shown
here.
The other elbow fitting does not have
any tape or tag. Please connect that one
to the red collet ring port labeled OUT in
the same manner.
NOTE: to remove the elbow fitting stem from the base, depress the
red collet ring fully against the base, while simultaneously, gently
pull out the elbow. Very little force is required, but some wiggling
and patience may be involved. Please do not use tools or brute
force. Please call for support 877-693-7873.
Installation Instructions
Tools Required
Towel · Pliers
1. COVER THE SINK DRAINS. Place the Home Master
®
Mini next
to sink. Either side OK.
2. Installation: Locate and unscrew the aerator tip from your
kitchen faucet. If the tip is stuck, cover the tip with a rag or
towel to protect its finish, and use a pair of pliers to loosen.