Perfect Water Technologies Home Master® Water Filter Installation & Service Manual HMF1C HMF2SdgC HMF2SmgCC HMF3SdgFeC HMF3SmgNCC HMF-CYO Customer Service Hotline 1-877-693-PURE
Home Master® Water Filter Owners Manual Contents: Instruction book: detailed descriptions, photos and troubleshooting guide Mounting bracket & screws assembled with housing cap(s) Housing sump(s) with filter(s), o-ring, and silicone grease Filter housing wrench Maintenance Schedule SEE PAGE 8 General System Specifications (See page 8 for additional details) • • • • Feed water: PSI 20 - 90 PSI ; for pressure greater than 75 PSI install a pressure regulator set to 75 PSI Feed water Temperature: 40˚ - 100˚
Home Master® Water Filter Owners Manual Installing The Whole House Filtration System Tools Required hacksaw Soldering iron or torch Power drill Teflon tape Safety glasses Towels Flat head screwdriver Medium Crescent wrench Monkey wrench (2) (2) (2) (1) (2) shut off valves hex nipples or pipe nipples pipe unions ground jumper cable pipe hangers Parts required (not included) bypass valve (s) (optional) pressure gauge (s) (optional) pressure regulator (as needed) Preliminary Notes • This installation gui
Home Master® Water Filter Owners Manual • Be sure to note inlet and outlet markings. The sediment filter is the first stage of the water filter. • Hard copper pipe generally comes in two types. Use the thicker "L" type copper pipe rather than thinner "M" type copper pipe. • Follow all local plumbing and building codes. Installation 1. Turn off the main line water shutoff valve to the house. 2. Next, open all plumbing fixtures in the house in order to drain the lines of as much water as possible. 3.
Home Master® Water Filter Owners Manual 12. Check pipe length and pipe union length to see if additional pipe length or union required. Join pipe union and pipe. 13. Fit pipe hanger on water OUT side for additional support. Connect ground jumper cable (if necessary) 14. A) Remove each filter from its packaging, B) replace it in the sump taking care that it slots over the standpipe at the bottom of the sump, 15.
Home Master® Water Filter Owners Manual Filter Change Instructions 1. For well water—shock chlorinate your well and pipes prior to removing filters. 2. Turn off the water supply to the system. Depress the red pressure release button on the top of the filter housing cap to relieve system pressure. If your system was not equipped with a pressure relief valve, leave open a nearby faucet. This will make removing the filter housing possible. 3.
Home Master® Water Filter Owners Manual purged. Inspect system carefully for leaks. If a leak is found, first follow the shut off de-pressurization procedure and then remove the housing to inspect the o-ring to ensure that it is seated properly. Then retighten. 10. Flush the system by turning on a few cold-water faucets. Allow the water to run until the air and carbon has been purged. Water may be cloudy initially.
Home Master® Water Filter Owners Manual Maintenance Guide ORing122* CFdgd2501-20BB CFrfgac20-20BB Cfrffe-20BB CfKDF85GCC-20BB CFpltn-20BB HMF1C x x MODEL HMF2SdgC HMF2SmgCC HMF3SdgFeC HMF3SmgNCC x x x x x x x x x x x x x x Inspect system for leaks, wear, & signs of stress Annually Annually Annually Annually Annually Inspect oring for damage & deformation* At filter change At filter change At filter change At filter change At filter change Sanitize System At filter change At filter change
