Instructions / Assembly

Customer Service Hotline [phone]-PURE
Page 5
Home Master
®
Water Filter Owners Manual
12. Check pipe length and pipe union length to see if additional pipe length or union
required. Join pipe union and pipe.
13. Fit pipe hanger on water OUT side for additional support. Connect ground jumper
cable (if necessary)
14. A) Remove each filter from its packaging, B) replace it in the sump taking care
that it slots over the standpipe at the bottom of the sump,
15. APPLY GREASE TO ORING AND HOUSING THREADS - TO ENSURE SMOOTH
OPERATION, OPENING , CLOSING, AND A PROPER SEAL.
FAILURE TO DO SO WILL LEAD TO INCOMPLETE CLOSURE & LEAKS, OR MAKE IT
NEARLY IMPOSSIBLE TO LATER OPEN THE UNIT
SOME GREASE IS ADDED AT THE FACTORY. PLEASE ADD MORE.
16. NOTE FILTER ORDER: The SEDIMENT filter treats the water first. The CARBON filter
treats the water last. In 3 housing units the IRON or Nanofiber filter will be in the
center position.
17. Fit sump with filter to housing cap hand-tighten, then fit snug with housing
wrench.
Turing the water back on
Open a nearby cold water faucet. (DO NOT USE HOT WATER) Then open your main
water supply slowly to flush the unit. The water will be blackish in color for some time -
this is normal carbon dust. Continue to run water until it runs clear and all air has been
purged. Shut the water off and let the unit sit for a while, and then flush it again. It is
not unusual for the water to appear "cloudy" for a day or so following installation - this
cloudiness is actually tiny air bubbles being purged from the carbon. This is normal,
harmless, and will clear up in a day or two.
• Even though there is filtered water in the cold water lines, the hot water heater is
still full of raw water. Through normal use, this water will be replaced with filtered
water in about 2 or 3 days. If you wish to accelerate the process, or if you have not
done so recently, please drain your hot water heater.
• This filter system should not be used with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before and/or
after the system.
1. Water filter systems should never be exposed to freezing temperatures -
severe damage to the filter and housings could result. Such damage is not
warrantied. DO NOT install the system where damage from a leak could cause water
damage.
• After prolonged periods of non-use (such as a vacation), it is recommended that the
system be flushed thoroughly for at least 5-10 minutes before using the water.