Use and Care Manual

Customer Service Hotline [phone]-PURE
Page 3
Home Master® Reverse Osmosis System—Owners Manual
Drilling hole for RO faucet
WARNING: Serious cracking and damage may
occur to your sink even if instructions are
followed exactly due to age and the
imperfections inherent in natural materials.
Instructions may not apply exactly to your
sink. Use caution – sink may be slippery.
1. Remove base cover plate from RO faucet
packaging. Line-up base cover plate with
other sink faucets. Check underside of sink for
spacing from trim, curvatures, and other obstacles. Don’t place spigot too close to
obstacles - leave yourself enough room under the sink to use hand tools. Either right
or left side of the sink is OK provided previous conditions are met. Mark center of
base cover plate with marker. Place towel underneath sink, below drilling site, to
collect fillings. Always wear protective eyewear and gear while drilling, and while
under sink.
2. Using 1” masonry bit and variable speed corded
power drill, slowly begin drilling through the sink.
Drill bit should be perpendicular to sink. Failure to
do so may cause the drill bit to slip and cause
bodily injury, and/or property damage. Rinse &
dry drill bit tip and sink area with cool water for
every 20 seconds of drilling to prevent drill bit
overheating and sink damage. Small localized
flaking or chipping may occur. Use caution –
drill bit may be very hot. DO NOT touch drill
bit. Electrical hazard! DO NOT allow power
drill electrical components to come into
contact with water. Use caution – sink may
be slippery.
Installing The Home Master® Reverse Osmosis
System
1. Mount RO Faucet*
1. Use existing hole, or drill 1” hole in sink top. See
page 3.
2. Slide metal escutcheon plate onto faucet shank.
3. Slide rubber washer onto faucet shank.
4. Insert shank through hole in sink.
5. Affix faucet to countertop with supplied wingnut,
position faucet and tighten.
Note: RO faucet is non-air gap. If an air gap faucet is
required for your installation, one can be provided to you
at no charge upon request with alternate drain saddle
and tubing. Call customer service 1-877-693-7873.