Use and Care Manual

Customer Service Hotline [phone]-PURE
Page 4
Home Master® Reverse Osmosis System—Owners Manual
2. Install EZ adapter on cold water line - Always wear protective eyewear.
Locate the cold water angle-stop (the main water lines under the sink – one hot
water, one cold water), and turn clock-wise to shut off the water. Locate 3/8” fitting,
typically found on the line out of the angle-stop or where the existing line connects
to the kitchen faucet. Disconnect the 3/8” fitting on either the angle-stop or the
kitchen faucet. Use Teflon tape on the EZ adapter and the angle-stop male threads,
and make sure o-rings are properly seated. Fit the EZ adapter and tighten. Make
sure EZ adapter ball valve is in the closed position then check for water pressure &
leaks on ball valve. Close EZ adapter valve, by turning the handle perpendicular to
the tube opening as shown below. Open angle-stop valve by rotating angle-stop
counter-clockwise. Have a bowl or cup nearby to catch water. Dry all parts,
check for leaks, and snugness.
3. Install drain saddle clamp -or- garbage disposal drain adapter
Drain saddle: Identify a vertical section of drainpipe with enough space to mount the drain saddle
clamp. NOTE: A horizontal section of pipe can be used, provided the drain saddle opening flows
downward into the pipe, like a manhole drops down into the sewer. DO NOT mount the drain saddle
between the P-trap and the wall. The drain pipe material can be either metal or plastic. Locate drain
hole template supplied with drain saddle clamp, and peel off its backing. Place
the template on the previously identified location of drainpipe for the drain
saddle clamp. Place ¼” drill bit inside template hole, and drill a hole into the
drainpipe. Drill through one side only. DO NOT drill a hole clean through both
sides of the drainpipe. Mount the drain saddle clamp on top of the template
with the holes aligned. You may use a screwdriver to align the holes. Fit drain
saddle clamp back-plate and screws. Alternate tightening screws on each side
of the drain saddle clamp to ensure an even, snug fit. NOTE: slimmer metal
drain clamp available.
Garbage disposal drain adapter installation
Drain Saddle
Step 2) EZ Adapter shown
on cold water anglestop