Use and Care Manual

Customer Service Hotline [phone]-PURE
Page 5
Home Master® Reverse Osmosis System—Owners Manual
4. Mount the Home Master® RO - Identify location for installing mounting
clip to hang the Home Master® RO filter cluster. Location should allow room for
the reserve tank, for connecting and disconnecting the unit, and enough room
for performing general service on the unit. Use supplied mounting clip and
mounting template located inside back cover. Home Master® RO should be
mounted vertically where the drain line out is on the bottom. Once mounted,
cut the zip-ties holding the tubing together.
4a. Mounting Permeate Pump (optional) - Mount permeate pump side-by-
side with the Home Master® RO using supplied mounting clip and screw.
IMPORTANT: permeate pump must be mounted with indicator arrow pointing
up. Indicator arrow is the large, center arrow. See mounting orientation
diagram below.
4b. Install refrigerator kit (optional)
Installation may vary according to make,
model, and age of your refrigerator. Make
sure refrigerator icemaker and water center
are turned OFF. Clean area below and around
refrigerator thoroughly. Use care when rolling
out refrigerator. Flooring may become
scratched, gouged or damaged from moving
refrigerator. Consult your local licensed
contractor or plumber for trimmed-in
refrigerators, or refrigerators without rollers.
Roll out refrigerator. Unplug refrigerator
electric plug. Locate water line in for
refrigerator. (Yours may already be connected
to a water line from wall. If so use local angle
-stop to shut off water. Disconnect female fitting.) Plan the route for the water line
from the Home Master® RO. Drill ¼” holes through the lower cabinetry, high along
the back wall just below the drawers. Make sure cabinet contents are removed, prior
to drilling, and ¼” tubing does not come into contact with drawers, doors, or sharp
objects. Smooth the holes free from splinters and sharp edges. [Alternate route for
refrigerator line -- run ¼” refrigerator tubing along the baseboard, and enter the
kitchen sink cabinet by drilling a ¼” opening in the bottom board of your kitchen sink
cabinet, towards the front baseboard.] Push tubing through the cabinetry holes from
the Home Master® RO to refrigerator. Allow 2-4’ of extra tubing at the refrigerator,
and position it so that it cannot be crushed or otherwise damaged while rolling the
refrigerator. Connect the female metal fitting from the refrigerator kit to the male
metal fitting on the refrigerator. Make sure all male metal fittings are thoroughly
Teflon taped to prevent leaks. Do not roll back refrigerator until the Home Master® RO
is fully installed and operational. IMPORTANT: Make sure shut off valve on the
refrigerator connection kit at the Home Master® RO is in the CLOSED position, where
Mounting Clip