Installation Guide
36 37
24
7, 12, 13, 15, 16, 17, 19, 20, 21
SAFETY PRECAUTIONS -
See pages 2-3 for denitions
TROUBLESHOOTING GUIDE
Troubleshooting Guide for The HomePlow Electric Lift
(Linear Actuator)
CONDITION POSSIBLE CAUSE CORRECTION
Plow operates 1. Bad wire connections. 1. Clean/Tighten wire connections.
slowly 2. Discharged battery. 2. Recharge battery.
3. Bad Linear Actuator. 3. Replace Linear Actuator.
4. Bad Remote Control Receiver. 4. Replace Receiver
.
Plow doesn’t 1. Bad wire connections. 1. Clean/Tighten wire connections.
operate 2. Discharged battery. 2. Recharge battery.
3. Bad Linear Actuator. 3. Replace Linear Actuator.
4. Bad Remote Control Receiver. 4. Replace Receiver.
5 Remote not communicating 5. Re-sync to receiver .
with receiver.
6. Battery dead on Remote Control. 6. Replace Battery and re-sync to receiver.
7. Bad Remote Control. 7. Replace remote and re-sync to receiver.
Re-sync instructions:
1. Make sure receiver is plugged in and has 12 volts.
4. Press the up and down button on remote simultaneously.
The receiver is now communicating with the remote.