Installation Guide

ManualsBrandsHome Styles ManualsBathBarnside Metro 13 in. W x 28.25 in. H x 11 in. D Etagere in Driftwood Gray

Hardware List

Part List

Home Styles Customer Service: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com,

888-680-7460, 877-831-0319

Tool(s) required for assembly: Level

88 5053 103

Three Tier Shelf

IMPORTANT

Carefully remove all the parts from the carton and

place them individually on a soft cloth to prevent

scratches or other damage.

Carefully and strictly follow these assembly instructions

to ensure a completed product as designed.

Do not use power tools above 8 volts to assemble.

Top

1 pc.

Hex Wrench

1 pc.

Small Hex Wrench

1 pc.

M6x16

Head Cap Bolt

24 pcs. (+1 extra)

Spring Washer

24 pcs. (+1 extra)

Flat Washer

24 pcs. (+1 extra)

Shelf

1 pc.

Base

1 pc.

Side Frame

2 pcs.

Stretcher

4 pcs.

Adjustable Pin

4 pcs. (+1 extra)

Summary of content (4 pages)

PAGE 1
88 5053 103 Three Tier Shelf IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A. Top 1 pc. D. Side Frame 2 pcs. B. Shelf 1 pc. E. Stretcher 4 pcs. C. Base 1 pc. Hardware List Hex Wrench 1 pc. Small Hex Wrench 1 pc. M6x16 Head Cap Bolt 24 pcs.
PAGE 2
Assembly Instructions 2/3 IMPORTANT Use a soft cloth between these parts and the floor. Do not use power tools above 8 volts to assemble. Do not tighten all the bolts until each part is properly assembled. The unit must be level to work properly. Use the included adjustable levelers to level. Keep Hex Wrench in a safe place as the bolts may need to be tightened up in the future.
PAGE 3
Assembly Instructions 3/3 STEP 3 Attach Top (A) and Base (C) to unit with Flat Washers, Spring Washers and Head Cap Bolts, tightening all bolts only half way. Flat Washer Spring Washer Head Cap Bolt A Tighten all Head Cap Bolts used in all steps. C STEP 4 Turn unit to its’ upright position. Insert Adjustable Pins into unit at desired level. (See Figure 2) Place Shelf (B) into position. Level unit by adjusting the adjustable levelers on the bottom of unit.
PAGE 4
CARE INSTRUCTIONS NEVER NEVER use glass cleaners on finished furniture. Ammonia chemically attacks the finish. allow liquids to remain on furniture. Absorption causes parts to warp and split and finishes to delaminate. Do not use power tools above 8 volts to assemble. Do not place in direct sunlight. Do not write directly on surface. PREVENT CRACKING PREVENT FADING PREVENT MARKING Do not place hot objects on surface. Do not use rubber based placemats. Do not use commercial waxes and polishes.