Manual

ManualsBrandsHome Styles ManualsFor Home5061-601

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Part List

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

Hardware List

88 5061 601

Orleans

King Headboard

Post

1 Pc.

Post

1 Pc.

Stretcher

1 Pc.

Rail

17 Pcs.

Upright

3 Pcs.

Stretcher

1 Pc.

Stretcher

1 Pc.

Top

1 Pc.

Hex Wrench

1 Pc.

Small Hex Wrench

1 Pc.

1/4x5/8”

Tapered Head Cap Bolt (short)

17 Pcs.(+1 extra)

1/4x1”

Bolt

14 Pcs.(+1 extra)

Outside Plate

2 Pcs.

Inside Plate

1 Pc.

1/4x2”

Bolt (long)

3 Pcs.(+1 extra)

1/4x1 1/2”

Tapered

Head Cap Bolt (long)

17 Pcs.(+1 extra)

1/4x1”

Tapered

Head Cap Bolt (middle)

2 Pcs.(+1 extra)

Summary of content (3 pages)

PAGE 1
88 5061 601 Orleans King Headboard IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List A. Top 1 Pc. D. Stretcher 1 Pc. B. Post 1 Pc. C. Post 1 Pc. G. Rail 17 Pcs. E. Stretcher 1 Pc. H. Upright 3 Pcs.
PAGE 2
Assembly Instructions 2 /3 IMPORTANT * Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * Do not tighten up all the bolts until each part is properly assembled. Tapered * Use a soft cloth between these parts and the floor. Head Cap Bolt (long) STEP 1 B E Insert Bolts and Bolts (long) into the pre-drilled holes of Stretcher (D), then attach 17X Rails (G) to Stretcher (D) and tighten.
PAGE 3
Assembly Instructions 3 /3 Tapered Head Cap Bolt (middle) Tapered Head Cap Bolt (short) Outside Plate Tapered Head Cap Bolt (short) STEP 3 Attach Uprights (H) to unit and tighten. (See Figure 3) Inside Plate E H E H Attach Outside Plates to unit with Tapered Head Cap Bolts (short) and Tapered Head Cap Bolts (middle). E H Attach Inside Plate to unit with Tapered Head Cap Bolts (short). Figure 3 E A Figure 4 Figure 5 STEP 4 Attach Top (A) to unit with Tapered Head Cap Bolts (short).