Instructions / Assembly

Part List

Hardware List

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the wood parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

Spring Washer

18 pcs.(+1 extra)

Flat Washer

18 pcs.(+1 extra)

Top

1 pc.

Side Frame

.1 pc

Side Frame

1 pc.

Front Rail

.1 pc

Back Frame

.1 pc

Stretcher

.1 pc

Stretcher

.1 pc

M6x38

Head Cap Bolt (long)

4 pcs.(+1 extra)

M6x16

Head Cap Bolt

18 pcs.(+1 extra)

Tools required for assembly : Level

Hex Wrench

1 pc.

Small

Hex Wrench

1 pc.

88 5079 15

Office Desk

PAGE 1
88 5079 15 Office Desk IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the wood parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List A. Top 1 pc. D. Front Rail 1 pc. B. Side Frame 1 pc. E. Stretcher 1 pc. C. Side Frame 1 pc. G. Stretcher 1 pc. F.
PAGE 2
Assembly Instructions 2/3 IMPORTANT * Do not tighten up all the Head Cap Bolts until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * Use a soft cloth between these parts and the floor. * After assembly, item must be level to work properly. Use the included adjustable levelers to level.
PAGE 3
Assembly Instructions 3/3 STEP 3 A Put Top (A) upside down on a soft cloth. Attach Top (A) to unit with Head Cap Bolts, Spring Washers and Flat Washers. STEP 4 Figure 2 Turn the unit to its’ upright position. To level the unit, adjust the adjustable levelers on the bottom of side frames. (See Figure 2) Note : Unit must be level to work properly.