Warranty

Assembly Instructions 2/2
STEP 1
Attach Seat (A) to Back Frame (F) with Flat Washers,
Spring Washers, Head Cap Bolts (long) and Head Cap
Bolts (short). (See Figures 1 and 2)
STEP 2
Put end of Stretcher (B) into hole in Back Frame.
Slide Leg (D) into position on the unit with other end of Stretcher
(B) in hole in Leg (D).
Attach Leg (D) to unit with Flat Washers, Spring Washers and
Head Cap Bolts. (See Figure 3)
Attach Stretcher (B) to unit with Wood Screws. (See Figure 4),
(See “Arrow” sticker indicating front side)
STEP 3
Put end of Stretcher (C) into hole in Back Frame.
Slide Leg (E) into position on the unit with other end of
Stretcher (C) in hole in Leg (E).
Attach Leg (E) to unit with Flat Washers, Spring Washers
and Head Cap Bolts.
Attach Stretcher (C) to unit with Wood Screws.
(See “Arrow” sticker indicating front side)
Tighten up all Head Cap Bolts and Wood Screws.
Figure 2
Figure 4
Figure 3
Spring Washer
Head Cap Bolt
(long)
Flat Washer
Spring Washer
Head Cap Bolt
(short)
Flat Washer
F
A
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep the Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
Spring Washer
Head Cap Bolt
Flat Washer
E
C
Wood Screw
Spring Washer
Head Cap Bolt
Flat Washer
F
D
B
Wood Screw
Arrow Sticker
Figure 1